Security Advices - Trebs Comfortice 99272 Mode D'emploi

6 Cleaning and Maintenance
This chapter provides you with important notices with regard to cleaning and maintaining the device.
Please observe the notices to prevent damages due to cleaning the device incorrectly and to ensure
trouble-free operation.
6.1 Cleaning

Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently. When
cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to
clean the inside and the outside surface of the Ice maker. Do not spray Ice maker with chemicals
or diluted agents such as acids, gasoline or oil. Rinse thoroughly before starting.

Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of
obstruction. Do not use mechanical devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer.

If the compressor stops for any reason such as water shortage, too much Ice, power off, etc... Do
not start the system right away, wait 3 minutes, and then re-start the Ice maker.
7 Troubleshooting
This chapter provides you with important notices with regard to operating the device. Observe the
following notices to avoid dangers and damages.

7.1 Security advices

ATTENTION

Repairs of electrical appliances must be carried out by qualified personnel who are trained by
the manufacturer.

Repairs performed by untrained persons may result in considerable hazards for the user and
damage the machine.
7.2 Troubleshooting
Problem
The compressor works
abnormally with a Buzzing
noise
Water shortage indicator
light is on
The Ice made is too large
and with pieces sticking
together.
Possible Cause
The voltage is lower than
recommended
1.There is no water
2.The pump is full of air
5.Ice of previous cycles left
in the water tray
6.The evaporator is too low
Suggested Solutions
Stop the Ice maker and do not restart
until the voltage is normal.
1.Press the stop button, fill with water,
wait 3 minutes and press the start button
to restart. When the water has reached
the fill line the ice maker will restart
automatically.
2.Remove the silicon stopper and let
several drops water runs out.
5.Stop the unit right away,restart the unit
till the ice in water tray melt down
6.Shift the evaporator a little.
28