Setup Location Requirements; Electrical Connection - Trebs Comfortice 99272 Mode D'emploi

PLEASE NOTE

If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of a
guarantee claim.

3.5 Setup location requirements:


In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfill the following prerequisites:

The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing
capacity.

Choose the setup location in such a way that children cannot reach the device.

The device is not intended to be installed in a wall or a built-in cupboard.

Do not set up the device in a hot, wet or extremely damp environment or near flammable
material. The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.

The installation and assembly of this device in non-stationary setup locations (e.g. on ships)
must be carried out by specialist companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.

3.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following instructions must
be observed for the electrical connection:

Before connecting the device, compare the connection data (voltage and frequency) on the
rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device If in doubt, ask your qualified electrician.

The electrical outlet must be protected by a 16A safety cut-out switch.

The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or gangs is
prohibited because of the danger of fire that is involved with this.

Make sure that the power cable is undamaged and has not been installed under the ice cube
maker or over hot or sharp surfaces.

The electrical safety of the device is only guaranteed if the device is connected to a properly
installed protective conductor system. Operations using an electrical outlet without a
protective conductor are prohibited. If in doubt, have the house installation checked over by
a qualified electrician. The manufacturer cannot be made responsible for damages that are
caused by a missing or damaged protective conductor.
25