Control Panel Operation - Trebs Comfortice 99272 Mode D'emploi

5.2 Control Panel Operation

'ON/OFF': Press it to turn unit on or off.
'ADD WATER': This light will come on with a
long noise 'DI' noise. You will need to add water
and press the 'STOP' then the 'START' button to
restart the Ice maker.
'ICE FULL' This light will come on with a 'DI, DI' noise when the ice has reached the maximum
capacity of the storage cabinet. Press 'ON/OFF' button to restart the Ice maker after some of the ice
has been taken away.
5.3 Operating Instructions
1. Open the lid and fill the water reservoir with water.
2. Connect to the power.
3. Press 'ON/OFF' button to turn unit on. The ice maker begins to work.
4. If indicator 'ADD WATER' is red with 'DI' noise, then take out the basket, then add water as
per step 1, then press 'ON/OFF' to restart the ice maker
5. If indicator 'ICE FULL' is in red with 'DI DI' noise, please take out the ice with the scoop.
6. Press 'ON/OFF' button to stop the machine.
PLEASE NOTE

Make sure the water level in the water reservoir is not over the Ice collecting tray.

For the first three cycles, the ice may be small and irregular in size.

If no water is pumped up to the water tray over two cycles but the water in water tank is enough,
then please move the unit ahead a little, then remove the silicon stopper, and let several drops
water runs out.

When the ice collecting tray is full please remove the ice immediately, Do not allow the ice
collecting tray to overfill.

Due to fast freezing, ice cubes may appear "Cloudy". This is air trapped in the water and will not
affect quality or taste of ice.
WARNING

If the icemaker is reused after a long time, the water pump may not pump sufficient water due to
an air block, the deficient water indicator turns on in this case . To correct this press the START
button again, then the icemaker will work normally.

To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced every
24 hours.

Always use fresh water before starting ice production either at initial installation or after a long
shut-off period.
DANGER

It is normal for the compressor and condenser surface to reach temperatures between 70°C and
90°C during operation and surrounding areas may be very hot.
27