Error Messages - Miele professional PW 6107 Mode D'emploi

Error messages

,
Repairs to electrical or steam operated
machines may only be carried out by a suitably
qualified person in accordance with national and
local safety regulations.
A message will appear in the display if there is a
problem either before starting a program or once it
has started:
The display remains dark.
There is no power to the machine.
^ Check the mains switch and the on-site fuses.
Power cut
y
Programme stop
Press the start button.
^ Once power has been restored press the START
button.
This error message can also indicate that the winding
on the motor has overheated.
^ Allow the motor to cool down.
Water inlet fault
M
Call the Service Department
if restart does not work.
i
^ Check the faucet and then press the START button.
Door lock fault
a
Call the Service Department
if restart does not work.
i
^ Push firmly on the door handle until you hear the
lock engaging. Confirm by pressing START.
Heating system fault
§
Programme stopped. Press start.
program will continue without heat.
i
^ To continue the program with heating press the
START button. If a disinfection program was
running the program will be cancelled if this
message appears.
Call the Service Department.
Drive motor fault
m
Programme stopped. Press the start button.
Motor overheating.
i
^ Allow the motor to cool down.
Imbalance fault
§
f
Call the Service Department
if restart does not work.
i
The imbalance is too great and the imbalance switch
has been activated.
^ Switch the machine off and on again. Then press
the START button.
Drain valve fault
§
Call the Service Department
if restart does not work.
f
i
^ Check the on-site drainage system and then press
the START button.
A defective drain valve must be repaired by a Miele
Service technician only.
Dispensing system fault
ö
f
Fill dispenser 1
Press the start button
i
Replace the empty container with a full one.
Problem solving guide
f
f
A
f
f
27