Identification Of The Devise; Main Components; Technical Data - FAR FHU 05 Traduction Des Instructions Originales

IDENTIFICATION OF ThE DEVISE

The FhU05 device is identified is identified from a marking
that shows company name and address of manufacturer,
designation of the tool, CE.
Always refer to the information on the riveting tool when
requesting technical service.
NOTE
Connect the riveting head to the FhU 05 device by means of the
holder cone (A) and fasten with the ring nut (G).
WARNING!
Before using the device it is absolutely necessary
to set the protection (C).

MAIN COMPONENTS

A) .........................................................................Cone holder
B) ..................................................................... Balancer hook
C) .................................................................................. Guard
D) ....................................................... Tensile strenght button
E) ........................................................................Oil tank plug
F) ................................................ Compressed air connection
G) .............................................................................. Ring nut
I) ................................................................ Protection bottom
12
Company name
and address
Designation of
the tool
FHU 05
Serial number
750349 - FHU05 – rev 08 - ( 05-2017 )
GB
G
A
W 17/32"-20
D
F

TEChNICAL DATA

• Working preessure .....................................................6 BAR
• Min. int. diam. of the compressed
air feeding hose ...........................................ø min. = 8 mm
• Air consumption per cycle .......................................10,9 Nl
• Maximum force .........................................6 BAR - 22725 N
• Stroke ................................................................... 19,5 mm
• Weight .................................................................. 2,650 Kg
• Working temperature .............................................-5°/+50°
• Root mean square in total acceleration
frequency (Ac)
to which the arms are subjected ..........................
•
A-weighted emission sound pressure level
•
Peak C-weighted instantaneous sound pressure
•
A-weighted sound power
AIR FEED
The air feed must be free from foreign bodies and humidity in
order to protect the device from premature wear and tear of
the components in movement, therefore we suggest to use a
lubricator group for compressed air.
FHU 05
B C
E
<
................. 77 dBA
...... <130 dBC
........................................... 89 dBA
I
2,5 m/s
2