WINK RELAY Guide De L'utilisateur page 9

9 Push all wires back into wall as far as possible.
10 Screw power box in place with the two (2) screws provided.
Depending on the size of your wall opening, the powerbox
may or may not fit completely inside the wall. Do not screw
the powerbox flush with the wall.
11 Turn power back on at circuit breaker.
12 On the front of the power box, you will see two buttons
and an LED light. If wired correctly, the LED light will
be solid green.
Press and hold the top button: the light attached to
load 1 should turn on. Press and hold the bottom button:
the light attached to load 2 should turn on. If the LED light
does not light up green, see Troubleshooting section.
16 17