WINK RELAY Guide De L'utilisateur page 11

9 Push all wires back into wall as far as possible.
10 Screw power box in place with the two (2) screws provided.
Depending on the size of your wall opening, the powerbox
may or may not fit completely inside the wall. Do not screw
the powerbox flush with the wall.
11 Turn power back on at circuit breaker.
12 On the front of the power box, you will see two buttons
and an LED light. If wired correctly, the LED light will
be solid green.
Press and hold the button the light was wired to: the light
should turn on. If the LED light does not light up green,
see Troubleshooting section.
20 21