WINK RELAY Guide De L'utilisateur page 7

4 Identify the line, load,
1
then disconnect from existing switch.
IF THERE ARE NO NEUTRAL WIRES, STOP AND CALL US
AT 1-844-WINKAPP.
5 Disconnect wires from existing switches.
6 Cut and strip wires, if necessary.
TO TRIM WIRES:
• Place wire in the trimming notch closest to the spring at the spot
it should be cut and press handle.
TO STRIP WIRES:
• Place insulated wire in the stripping notch that fits the wire gauge.
Press and hold handle closed. Rotate wire until a cut is made around
the insulation and pull insulation off the wire.
12
and neutral wires,
2 3
3
1
2
13