Double Gang Box - WINK RELAY Guide De L'utilisateur

DOUBLE GANG BOX INSTALLATION (RECOMMENDED)
A double gang box is a double light switch that controls
two loads.
7 Connect wires from gang box to wires on the power box.
NOTE: Colors of wires may vary depending on your gang box.
Consult a qualified electrician if you are unsure about a wire.
Connect the line wire from the gang box (usually black)
to the black 2-pole connector on the power box.
Connect one of the load wires from the gang box
(usually black) to one of the red 2-pole connectors
on the power box.
2
Connect the other load wire from the gang box (usually black)
to the other red 2-pole connector on the power box.
Connect the neutral wire(s) from the gang box (usually
white) to the white 4-pole connector on the power box.
8 There are no bare copper (ground) wires on the power box,
however there will be ground wires in your wall; connect them
all using the green 4-pole wire connector (included.)
NOTE: Your ground wires may already be attached together
with a connector. If this is the case, you will not need to
complete this step. WARNING: Cap any loose wires.
14
1
3
4
1
2
3
4
15