Preference > Vcr - Tech Line DVRC 800 Mode D'emploi

DF-H3F12S-RL-W(GB) 2007.9.10 12:52 PM
VPS/PDC
VPS/PDC is a service provided by some stations to
enable you to perform timer recordings precisely even
if the broadcaster delays the start time of the program
slightly. The time you enter is the VPS/PDC time so
this must be correct. Not all stations offer VPS/PDC, in
which case the player will start at the time you enter
and not the actual start time of the programme.
If you wish to start recording at a specific time with it
being adjusted by the VPS/PDC system in the event of
a delay, switch VPS/PDC on.
Follow the same procedure as 'Auto Clock Setting' to
set the 'VPS/PDC' status.
Preference > Auto Setting
"VPS/PDC" and "Auto Clock Set" are not
provided for some countries.
28
˘ ` 28 mac001
Auto Clock Setting On
VPS/PDC Off
√
†
Confirm Back Exit
ENTER MENU SETUP
1200DPI 100LPI
Preference > VCR
This feature enables you to search for Index marks or
specific times on your VHS tapes.
1 While 'Preference' is selected, press [†] to select
'VCR'.
2 Press [ENTER].
3 The 'VCR' submenu is displayed.
4 Select 'Index+', 'Index–' or 'Go To Zero'.
If you select 'Index+' (or 'Index–') and press
[ENTER], your DVD Recorder+VCR will locate
your index mark and begin playback.
If you select 'Go To Zero' and press [ENTER],
your DVD Recorder+VCR will wind to the position
0:00:00 and stop.
Preference
Video
Audio
Parental Control
Change Password
Auto Setting
VCR
Confirm
ENTER MENU
The VCR menu is activated only when a video
cassette tape is inserted and DVD Recorder+VCR
is in VCR mode.
Setup menu
Index +
Index -
Go To Zero
†
Back Exit
SETUP