Bosch PMD 7 Notice Originale page 22

OBJ_BUCH-1913-002.book Page 22 Monday, September 23, 2013 12:33 PM
22 | English
Troubleshooting
–
Cause Corrective Measure
Signal LED 2 does not illuminate
Measuring tool is not Slide the On/Off switch into position "On".
switched on
Measuring tool has Slide the On/Off switch first into position "Off" and
switched itself off then into position "On".
Batteries have not Insert batteries. Pay attention to the polarity.
been inserted or
been inserted incor-
rectly
Flat or rechargeable Replace batteries. Do not use rechargeable
batteries inserted batteries.
Signal LED 2 illuminates yellow or red, even though no metal is
located within the vicinity (warning of metal objects)
Ambient tempera- Only use the measuring tool within the specific
ture is too high/too temperature range of 0 °C –40 °C .
low
Severe temperature Wait until the measuring tool acclimates to the
change ambient temperature.
Auto calibration not Perform a manual calibration.
successful
Signal LED 2 lights yellow or red over large measuring area on the
wall (warning of metal objects)
Many, closely Pay attention to the pitch of the signal sound to dif-
spaced metal ob- ferentiate between individual metal objects. Metal
jects objects that are too closely spaced, cannot be de-
tected separately.*
Metal as building A reliable detection is not possible with metallic
material building materials (e.g. foil-laminated insulation
materials, heat sinks).*
Auto calibration not Perform a manual calibration.
successful
2 609 140 996 | (23.9.13)
Causes and Corrective Measures
Bosch Power Tools