Bosch PMD 7 Notice Originale page 17

OBJ_BUCH-1913-002.book Page 17 Monday, September 23, 2013 12:33 PM
Declaration of Conformity
We declare under our sole responsibility that the product described un-
der "Technical Data" is in conformity with the following standards or
standardisation documents:
EN 61010-1:2010-10, EN 61326-1:2006-05,
EN 301489-3:2002-08, EN 301489-1:2011-09,
EN 300330-1:2010-02, EN 300330-2:2010-02 according to the provi-
sions of the directives 2011/65/EU, 1999/5/EC.
Henk Becker
Executive Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 26.08.2013
Assembly
Inserting/Replacing the Batteries
Alkali-manganese batteries are recommended for the operation of the
measuring tool.
To open the battery lid 5, press on the latch 4 and fold the battery lid up.
Insert the batteries. When inserting, pay attention to the correct polarity
according to the representation on the inside of the battery compartment.
 If the measuring tool is not used for longer periods of time, remove
the batteries. The batteries can corrode or self-discharge after pro-
longed storage.
Operation
Initial Operation
 Protect the measuring tool against moisture and direct sun light.
 Do not subject the measuring tool to extreme temperatures or var-
iations in temperature. As an example, do not leave it in vehicles for
Bosch Power Tools
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
2 609 140 996 | (23.9.13)
English | 17