ABAC STAPLER Notice D'utilisation Et D'entretien page 25

3. SNAP-ACTION RELEASE SAFETY DEVICE 3. SNAP-ACTION RELEASE SAFETY DEVICE
3.1 CHECKING THAT THE TOOL IS WORKING
PROPERLY
The operator's finger must not be on the trigger
and the tip of the tool must be positioned on the
work surface.
Push the tool towards the work surface to raise
the safety device, and squeeze the trigger.
Release the trigger after every shot. Move the
tool to the next position and repeat the above
procedure again.
3.2 CHECKING THE TOOL
3.2.1 Disconnect the air supply from the tool (1).
3.2.2 Empty the magazine (2).
WARNINGS: CHECK AND REPLACE DAMAGED
OR WORN PARTS OF THE TOOL. THE SAFETY
WARNING LABELS MUST BE REPLACED IF
UNREADABLE.
3.2.4 Connect the air supply to the tool (3).
3.2.5 Lower the tip against the work area
without squeezing the trigger. The tool must not
trigger continuously. Do not use the tool if this
happens.
Move the tool out of the work area. The safety
device must return to its original lowered
position. Squeeze the trigger. The tool should
not operate. Do not use the tool if this occurs (4).
1
2
3
4
25
EN