EINHELL Bavaria BTS400 Mode D'emploi page 8

Anleitung BTS 400_SPK1:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for
the safety instructions.
2. Layout (Fig. 1-2)
1. ON/OFF switch
2. Overload display
3. Cutting depth limiter
4. Guard hood
5. Articulated axle of the guard hood
6. Connection for dust extractor
7. Locking device for safety hood
8. Nut for safety hood
3. Technical data
Voltage: 230 V ~ 50 Hz
Power input:
Idle speed:
Cutting depth: max. 12 mm
Saw blade: 50.8 mm Ø
Blade holder:
Blade thickness:
L sound pressure level: 94.5 dB(A)
pA
L sound power level: 105.5 dB(A)
WA
Vibration a w :
Weight:
Totally insulated
8
25.01.2007 7:55 Uhr
4. Proper use
The mini hand-held circular saw is designed for
sawing straight cuts in wood, wood-type materials
and plastics.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
5. Working with the mini hand-held
circular saw
Inserting and changing the blade (Fig. 1-4)
Important! Always pull out the power plug before
doing any work on the circular saw!
Unscrew the Allen nut (8) and pull out the screw
(5).
Take the guard hood (4) off the tool.
Insert the Allen key (a) into the free end of the
drive shaft (b).
Insert the second Allen key (c) into the mounting
screw (d) of the blade.
Use the one Allen key (a) to hold the shaft and
undo the screw with the other Allen key (c).
Insert or remove the saw blade and mounting
rings, paying attention to the running direction
(see arrow on the housing)!
Use the one Allen key (a) to hold the shaft and
tighten the screw with the other Allen key (c).
Mount the guard hood (4) again.
400 W
Setting the cutting depth (Figure 5)
8000 rpm
Undo the setting screw (3).
Set the cutting depth in accordance with the
11 mm Ø
scale (a).
0.8 mm
When cutting wood or plastic the selected
cutting depth should be a little larger than the
material thickness.
To prevent damage to underlying surfaces, the
1.88 m/s 2
cutting depth can be set exactly to the thickness
1.5 kg
of the material. However, this will result in a
II / ®
slightly unclean cut.
Seite 8