EINHELL Bavaria BTS400 Mode D'emploi page 10

Anleitung BTS 400_SPK1:_
GB
6. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the tool
immediately after you use it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
toolʼs plastic parts. Ensure that no water can get
into the interior of the tool.
Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be
replaced by anyone but a qualified electrician.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
Ordering spare parts
Please provide the following information on all
orders for spare parts:
Model/type of tool
Article number of the tool
ID number of the tool
Number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
7. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
10
25.01.2007 7:55 Uhr Seite 10
Defective components must be disposed of as
special waste. Ask your dealer or your local council.