Publicité
Les langues disponibles
Les langues disponibles
CONTROL PANEL FOR SLIDING DOOR OPENERS
• MICROPROCESSOR-BASED CONTROLLER
• LED INPUT STATUS INDICATORS
• ENCODER SENSOR FOR SELF-LEARNING OF TRAVEL
• BATTERY CHARGER BOARD (INTEGRATED)
• BATTERY CONNECTOR
• DIAGNOSTICS LEDs
ATTENTION:
-
do not use single cables (with one single wire), ex. telephone cables, in order to avoid
breakdowns of the line and false contacts;
-
do not re-use old pre-existing cables;
TESTING
Once the connection is completed:
• The green LEDs must all be lit (they correspond to a Normally Closed input each). They
switch off only when the controls they are associated to are involved.
• The red LEDs must all be off (they correspond to a Normally Open input each); they light
only when the controls they are associated to are involved.
TECHNICAL CHARACTERISTICS
Board power supply
Max motor power DC
Fast acting fuse entrance 230V AC (F5 - 5x20)
Fast acting fuse for protection of auxiliary circuits 24 V CC (F1 - 5x20)
Fast acting fuse for motor protection 40Vcc (F2 - 5x20)
Motor power supply circuits voltage
Auxiliary device circuits supply voltage
Logic circuits supply voltages
Operating temperature
WORKING PROGRAMS
Five different working programs can be selected (through mechanical program switch or TAU-
PROG handheld device):
• "SOLO ENTRATA" (ENTRY ONLY)
• "SOLO USCITA" (EXIT ONLY)
• "ENTRAMBI I SENSI" (AUTO)
• "SEMPRE APERTA" (HOLD OPEN)
• "BLOCCATA CHIUSA" (LOCK)
Program
"SOLO ENTRATA"
(ENTRY ONLY)
20
Description
Entering Traffic
DC16
Active inputs
Outside Radar
Close (Latching Relay)
Emergency
20V+40V AC - 50 Hz
100 W - 40 V DC
3.15A
2 A
6,3 A
40 V DC
24 V DC
5 V DC
-20 °C ÷ +55 °C
Remarks
Publicité
