6.4 Attaching the network cable
The maximum network cable (CAT7) length from the camera to the nearest active network point
(e.g. network switch) should not exceed 100 metres.
6.5 Aligning the camera
Instructions for how to align the camera are given in the quickstart guide for the relevant IP
camera IPCBXXXX.
6.6 Zoom and focus settings
IPCB24500 / IPCB34500 / IPCB64500 / IPCB74500
The cameras have a built-in Motor Vario zoom lens. It is possible to change the zoom factor or
adapt the focus via the camera's web interface ("installer" access).
The zoom factor can be changed in stages, whereas the focus is automatically set for each of
these zoom factors. It's possible to change the focus of each zoom factor via the camera's web
interface ("installer" access). The change will be saved to the camera (over button "SAVE" on
main page of "installer" access). When the camera undergoes a factory reset, the factory-set
zoom/focus relationship is reset too.
64