Access To The Network Camera Via The Internet Explorer; Defining A Password To Prevent Unauthorised Access - Abus eyseo. TV7230 Instructions D'installation

Access to the network camera via the Internet Explorer

Defining a password to prevent unauthorised access

When delivered, no administrator password is defined for the PAN/TILT network camera.
The PAN/TILT network camera asks for this number at the start of operation. For security reasons, the
administrator should define a new password immediately. After the new administrator password is
stored, the PAN/TILT network camera asks for the user name and password every time it is accessed.
The administrator can define up to twenty (20) user accounts. Every user has access to the PAN/TILT
network camera, but not to the system configuration. Some system-critical functions are reserved for
the administrator, such as system configuration, user administration and upgrading software
programs. The administrator's user name is always root and cannot be changed. Following a
password change, the browser displays an authentication window and asks for the new password.
After changing the password, you cannot restore the original administrator password. Your only option
is to reset all default factory settings/parameters.
To enter a password:
Open the Internet Explorer and enter the IP address of the camera (e.g.: <http://192.168.0.99>).
You are prompted for authentication:
You are now connected with the PAN/TILT network camera and can see a video stream.
Note: It may happen that your PC's security settings prevent a video stream. You can change
the security settings to a lower level under "Tools/Internet Options/Security". Make sure you enable
Active X Control Elements and Downloads.
8