Bosch PHO 1 Notice Originale page 19

OBJ_BUCH-437-001.book Page 19 Tuesday, September 18, 2007 2:34 PM
Only sharp blades achieve good cutting capacity
and give the machine longer life.
Beveling Edges (see figure G)
The V-groove 9 in the front planer base plate al-
lows quick and easy beveling of workpiece edg-
es. For this, place the planer with the V-groove
onto the edge of the workpiece and guide it along
the edge.
Planing with Parallel/Beveling Guide
(see figures D–F)
Mount the parallel guide 18 or beveling guide 22
to the machine using the corresponding fasten-
ing bolt 21. Depending on the application, mount
the rebating depth stop 25 with fastening bolt 24
to the machine.
Loosen the locking nut 20 and adjust the request-
ed rebating width on the scale 19. Tighten the
locking nut 20 again.
Adjust the requested rebating depth accordingly
with the rebating depth stop 25.
Carry out the planing procedure several times un-
til the requested rebating depth is reached.
Guide the planer applying sideward supporting
pressure.
Beveling with the Beveling Guide
When beveling rebates
and surfaces, adjust the
required slope angle
with the angle adjust-
ment 23.
Bosch Power Tools
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article number
given on the type plate of the machine.
WARNING! Important instructions for connect-
ing a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this power tool, it
must be disposed of safely.
Replacing the Drive Belt (see figures H–I)
Unscrew screw 7 and take off the belt cover 6.
Remove the worn drive belt 26.
Before assembling a new drive belt 26, clean
both pulleys 27 and 28.
Place the new drive belt 26 on the small pulley 28
first and then work the drive belt 26 onto the
large pulley 27 by hand while rotating it.
Reattach the belt cover 6 and tighten with the
screw 7.
English | 19
1 609 929 M00 | (18.9.07)