Bosch PHO 1 Notice Originale page 17

OBJ_BUCH-437-001.book Page 17 Tuesday, September 18, 2007 2:34 PM
Technical Data
Planer
Article number
Rated power input
Output power
No-load speed
Planing depth
Rebating depth
Planing width, max.
Weight according to
EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Declaration of Conformity
We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
05.06.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Bosch Power Tools
Assembly
Before any work on the machine itself, pull
PHO 1
the mains plug.
0 603 272 2..
Changing the Tool
W 500
Be cautious when replacing the planer
W 250
blades. Do not grasp the planer blades by
rpm 19000
the cutting edges. Possible danger of injury
1 – 1.5
mm due to the sharp cutting edges of the planer
blades.
0 – 8
mm
Use only original Bosch carbide blades (TC).
mm 82
The carbide blade (TC) has 2 cutting edges and
can be reversed. When both cutting edges are
kg 2.0
dull, the planer blade 13 must be replaced. The
/ II
carbide blade (TC) may not be resharpened.
Disassembling the Planer Blade(s)
(see figure A)
To reverse or replace the planer blade 13, rotate
the blade drum 10 until it is parallel to the planer
base plate 8.
Assembling the Planer Blade(s) (see figure B)
The guide groove of the planer blade always en-
sures continuous height adjustment when re-
placing or reversing it.
If required, clean the blade seat in the clamping
element 11 and the planer blade 13.
When assembling the planer blade, ensure that it
is seated properly in the blade holder of the
clamping element 11 and aligned flush at the side
edge of the rear planer base plate 8. Afterwards
tighten the 2 fastening screws 12 again with the
Allen key 14.
Note: Before restarting, check if the fastening
screws 12 are tightened well. Rotate the blade
drum 10 by hand and ensure that the planer
blade does not graze.
Loosen the two fastening screws 12 with the
Allen key 14 by approx. 1 – 2 turns.
If necessary, loosen the clamping element 11
by giving it a light blow with a suitable tool
(e.g. a wooden wedge).
Push the planer blade 13 sidewards out of
the blade drum 10 with a piece of wood.
1 609 929 M00 | (18.9.07)
English | 17