Mounting A Filter; Focus Limit Switch; Focus Stop Buttons; Shooting Cautions - Olympus ZUIKO DIGITAL ED300mm f2.8 Mode D'emploi

Mounting a Filter

1. ND4-43/ND8-43
① Remove the SCF-43 clear filter from the filter holder
• The DPF-43 drop-in PL filter should not be used
② Insert the filter holder in the lens's mounting
③ Firmly push the filter holder in until it clicks.
• After mounting the filter holder, make sure that it
■Notes:
④ When detaching the filter holder, push and hold
2.
Drop-in PL filter DPF-43
① Attach the DPF-43 drop-in PL filter to the
lens body so that the ▲ is pointing to the
front.
• Push the filter in until it clicks.
16
and attach the ND4-43 or ND8-43 to the filter
holder.
with the filter holder.
section.
does not come off.
If the filter holder is improperly mounted, it may
come off. In this case, the unit's dust and drip re-
sistance may be compromised.
the detach button and pull out the filter holder.
② Rotate the rotary lever to adjust the level
of surface reflection elimination.

Focus Limit Switch

This switch limits the autofocus range to speed up focusing in each
∞
-2.4m
range.
∞
-6m 6-2.4m
Select the optimum mode according to the shooting distance.
Close-up shooting : Autofocus is performed between 6 meters and
2.4 meters.
: Autofocus is performed from ∞ (infinity) to
Normal shooting
2.4 meters.
: Autofocus is performed from ∞ (infinity) to
Distant shooting
6 meters.

Focus Stop Buttons

• By holding down one of the focus stop buttons, you can deactivate
autofocus operation and fix focus at the point where the button
was pressed.
• Four buttons are provided. All have the same effect.

Shooting Cautions

• Be sure to attach the hood when shooting against the light.
• When two or more filters are used or a thick filter is used, part of the picture may be cut off or
obscured.

Attaching Lens Cap LC-140

17