Trimming Beard - Panasonic ER-GB44 Mode D'emploi

2
2
Mount the comb attachment to the
main body until it clicks.
Trimming height
Comb attachment
(estimate)
Comb attachment
1 mm to 10 mm
for beard
3
3
Turn the dial to move the comb attachment to
the desired trimming length (between 1 mm
and 10 mm).
Trimming length
1 1.5 2 2.5 3 3.5 4 4.5 5 5.5
(mm) (estimate)
Indicator 1 1.5 2 2.5 3 3.5 4 4.5 5 5.5
Trimming length
6 6.5 7 7.5 8 8.5 9 9.5 10
(mm) (estimate)
Indicator 6 6.5 7 7.5 8 8.5 9 9.5 10
• Actual beard length will be a little longer than the
height you set.
Removing the comb attachment
Remove the comb attachment from
the main body.

Trimming beard

Dry trimming
Trimming with the comb attachment
Do not use with shaving foam applied or when the
beard is wet.
Press the power switch to turn off the main
1
1
body.
2
2
Mount the comb attachment and adjust the dial.
(See this page.)
Press the power switch to turn on the main
3
3
body.
4
4
Holding the main body
with the power switch
facing up, trim by
bringing the blade in
contact with the skin and
moving the main body
against the flow of the
beard.
• Hair trimmings may collect
inside the attachment
when a large volume of
beard is cut, so discard
hair trimmings after each
use.
13