Important Information - DURAVIT SensoWash Starck e 610001 00 2 00 4300 Notice De Montage

Important information

About the mounting instructions
These mounting instructions come as part of
the Duravit shower toilet and should be read
carefully prior to installation.
Explanation of the key words and symbols
DANGER! At high risk of fatal hazards or
serious injuries
NOTE! To avoid property damage
Link to the installation information in
this section
Inspection (e.g. for scratches)
Target Readership and Qualifications
The Shower WC and associated water connec-
tion may only be installed by qualified plumb-
ers. The electrical installation may only be
carried out by qualified electricians.
NOTE!
Local installation regulations, country-specific
standards and the low voltage directives must
be observed at all times.
NOTE!
DO NOT not install the Shower WC in rooms
where there is a danger of frost. The room
temperature must not be less than 4 °C.
NOTE!
Condensation may form when the Shower WC
unit is brought from a cold location to a warm
one.
> Leave the unit switched off for a few hours.
SensoWash e_MAL_56897/16.11.4
Safety instructions
DANGER!
Risk of fatal electric shock.
> Do NOT remove individual Shower WC
components.
Installation Instructions
Please read pre-installation data sheets prior
to the installation. These are available to
download on the Internet at www.duravit.com.
An installation video of the complete shower
WC is available at pro.duravit.com/mounting.
Simply use this QR code
Checking the installation requirements
1
(Diagram 1)
The installation of the WC ceramics
with pre-installation of the Shower WC
water and power supplies is described in
separate instructions.
> Ensure that the supplies and WC
ceramics have been installed and
mounted according to the instructions
and regulations.
Positioning the remote control mounting
23
bracket (Diagram 23)
> Continue with step 26 to install the anti-
theft device.
> Follow the instructions up to step 25 to
install the mounting bracket without the
anti-theft device and then continue with
step 31.
31
Removing the seat (Diagrams 31 to 39)
> Remove the seat as required, e.g. for
cleaning or emptying.
5