Jotul I 570 Manuel D'installation Et Données Techniques page 72

ENGLISH
Fig. 8
11. Place the shield plate (fi g. 8 A) on the joints of the legs
of the insert.
12. Replace all parts that were removed to facilitate handling
of the insert.
13. Reassemble the screen plate that was previously removed
(see point. 4).
Fig. 9
14. Unscrew the upper screen plate at the rear (fi g. 9 A). Turn
it upside down and fasten using the same screws it was
previously fastened with.
72
Fig. 10
Fire bars
Thread stops are threaded on the studs (fi g. 10 A) on the back
of the front frame.
4.2 Installation
Mounting for chimney
1. The insert should be test mounted fi rst, without holes being
made in the chimney. See (fi g. 1) for fi rewall dimensions.
2. The insert must be mounted with a Ø200 mm fl ue. This must
be of an approved thickness.
3. Place the insert in its fi nal position.
Fig. 11 g
4. Use a gasket (fi g. 11 A) and place the fl ue pipe in the smoke
outlet of the insert.
NB! It is important that the joints are completely tight. Air
leakage or the like can damage the function.