Gram GEC Série Manuel D'utilisation page 13

4. Select the menu CAL 2, press the
auxiliar platform (B)
5. Select the menu CAL 3, press the
6. Select the menu CAL 4, press the
configuration.
7. Select the menu CAL 5, press the
procedure.
Note: To configurate the menus CAL 4 and CAL 5, is necessary to remove
the jumper JP3 from PCB. Once completed the configuration, put again
the
jumper JP3 at the place of origin.
GENERAL CONFIGURATION (CAL 1)
Press the C key to navégate through different options and press the
to confirm the introduced data.
1. AUTO TURN-OFF
Display
Aut.oFF
oFF
Aut.oFF
5
Aut.oFF
10
Aut.oFF
20
Aut.oFF
30
Comments
Auto Turn-off disabled.
Auto Turn-off after 5 minutes of not use.
Auto Turn-off after 10 minutes of not use.
Auto Turn-off after 20 minutes of not use.
Auto Turn-off after 30 minutes of not use.
12
to access to configuration of
to access to print configuration
to access to calibration
to access to lineality calibration