Publicité
Les langues disponibles
Les langues disponibles
English
1 General
Installation and Operating Instructions
About this document
The language of the original operating instructions is English. All other languages
of these instructions are translations of the original operating instructions.
These installation and operating instructions are an integral part of the product.
They must be kept readily available at the place where the product is installed.
Strict adherence to these instructions is a precondition for the proper use and
correct operation of the product.
The installation and operating instructions correspond to the relevant version of
the product and the underlying safety regulations and standards valid at the
time of going to print.
EC declaration of conformity:
A copy of the EC declaration of conformity is a component of these operating
instructions.
If a technical modification is made on the designs named there without our
agreement or the declarations made in the installation and operating instruc-
tions on product/personnel safety are not observed, this declaration loses its
validity.
2 Safety
These operating instructions contain basic information which must be adhered
to during installation, operation and maintenance. For this reason, these oper-
ating instructions must, without fail, be read by the service technician and the
responsible specialist/operator before installation and operation.
It is not only the general safety instructions listed under the main point "safety"
that must be adhered to but also the special safety instructions with danger
symbols included under the following main points.
2.1 Indication of instructions in the operating manual
Symbols:
General danger symbol
Danger due to electrical voltage
NOTE:
Signal words:
DANGER!
Acutely dangerous situation.
Non-observance results in death or the most serious of injuries.
WARNING!
The user can suffer (serious) injuries. 'Warning' implies that (serious) injury
to persons is probable if this information is disregarded.
CAUTION!
There is a risk of damaging the product/unit. 'Caution' implies that damage
to the product is possible if this information is disregarded.
14
WILO SE 11/2015
Publicité
