Descaling - Jura SUBITO Mode D'emploi

Bed.subito d/F/I/E/SP/NL 22.10.2001
3. Set the selector switch to the «Coffee» position (Fig. 4).
4. Switch the pump on (Fig. 4), let approx. 100 ml run out
through coffee outlet and switch the pump off again. Wait
for 2 minutes.
5. Repeat step 4 five times.
6. Turn the cover to the cleaning position and remove
(Fig. 9). Rinse well.
7. Turn on the pump switch. Switch off again after 1 minute.
8. Clean the top with a brush or a damp cloth (Fig. 11).
9. Fit the cover and turn into the coffee-brewing position.
Then lower the lever twice with the release lever pulled
out (Fig. 3) and lift again (Fig. 5).
10. Turn the cover to the filling position.
11. Empty the containers for residual water and coffee
grounds and replace.

10. Descaling

To keep your machine functioning correctly, it must be
periodically descaled. How often this must be done depends
on the hardness of the water. You can find out how hard your
water is by asking the local water board. In the case of hard
water (approx. 20° dH), we recommend that you descale the
machine every three months. For decalcification purposes
we recommend use of the Jura decalcifying tablet. These are
available from your local dealer.
Note: The machine must be descaled if there is a notice-
able reduction in coffee flow and/or the tempera-
ture of the coffee decreases.
Important: The Jura decalcifying tablet was specially designed
for Jura devices and in particular for the decalci-
fication cycle. You can therefore be sure of opti-
mum results.
42
17:39 Uhr Seite 42
10.1 Decalcification process
Preparation for decalcification
1. Switch the appliance off and allow to cool for approx. 1
2. Drain the residual water tray and the grounds container
3. Turn the cover through
4. Pull the release lever and push down the twist-lever,
5. Pour 0.7 litres of water into a container and completely
6. Now pour this solution into the water tank.
7. Position a vessel of the required capacity under the swivel-
Procedure
8. Set the selector to the «Water position» (
9. Turn the tapping switch (
10. Turn the main switch ( ) on and draw off approx. 125 ml
11. Turn the main switch ( ) off and allow the decalcifying
12. Repeat Steps 10 and 11.
13. Empty the vessel and reposition under the height-adjust-
14. Set the selector to the «Coffee position» (
15. Turn the main switch ( ) on and draw off approx. 150 ml
16. Turn the main switch ( ) off and allow the decalcifying
hour if it has been in recent use.
and replace.
1 / turn into the coffee brewing
4
position (Fig. 2).
exerting moderate force until it can be felt to reach the
end of its travel (Fig. 3).
dissolve the contents of a blister pack (2 tablets).
ling water and steam outlet spout.
) on.
(1 large cup) from the contents of the tank.
solution to work for approx. 10 minutes.
able coffee spout.
of the contents of the tank.
solution to work for approx. 10 minutes.
) position.
) position.