Sanding Disc; Sanding Belt; Operation; On/Off - HOLZMANN MASCHINEN BT 46 Mode D'emploi

OPERATION

14.2.3 Sanding disc

To change the sanding disc, dismount worktable, remove sanding guard, replace sanding disc,
and fix sanding guard again (fig.h).

14.2.4 Sanding belt

Move tension lever to the right to release the sanding belt tension (fig.i). Place the sanding belt
over the drive and idler drums, making sure that the inside direction arrow points down, towards
the drive drum.
To adjust the sanding belt run you have to turn the adjustment knob (fig.k). Try the run manual.
If the run is still not central, repeat the adjustment.
14.3 Operation

14.3.1 ON/OFF

To switch on push the green button („I") for the time of 1 second.
To switch off, push the button „O".

14.3.2 Surface sanding on sanding belt

For surface sanding, press the workpiece gently with both hands against the sanding belt and the
safety fence (fig.m). To achieve a better sanding result, you can move the workpiece gently back
and forth.

14.3.3 End sanding on sanding belt

For end sanding, bring the sanding aggregate in vertical position and mount the worktable
(Fig.n). Hold the workpiece firmly with both hands and press it gently against the sanding belt.
Therfor move the workpiece gently back and forth.

14.3.4 Sanding curved edges

For sanding curves, hold the workpiece firmly with both hands and exert slight pressure on the
sanding belt. Grinding internal rounding only at the front deflection roller (fig.o).
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 31
BT 46