Carson HM-38 Mode D'emploi page 19

Horizontal level
of the swashplate
L-shape
ballcrank
Fastening the rotor blades
The rotor blades must be able to align themselves 180° to each
other solely by the centrifugal force.
1. Main rotor blade Inspection.
a. Check whether the fixing screws of the main rotor blades
are too loose or tight.
b. Check the tracking problem.
2. Main rotor blade adjustment.
a. If the fixing screws are too loose, tighten to some
extent; otherwise, unscrew to some extent.
b. If there exists a tracking problem, adjust long or short the
steering linkage.
Round ballcrank
Servo I-shape Aileron
pulling rod ballcrank servo
CARSON Helikopter MARINES HM-38 50 050 7025
Servo
pulling rod
Elevator I-shape
servo ballcrank
GB
Horizontal level
of the swashplate
L-shape
ballcrank
Servo
pulling rod
Steering linkage
Fixing screw
19