Bebeconfort CabrioFix Mode D'emploi page 11

EN
Shell
1
B elt buckle
2
C rotch strap with belt pad
3 a
S houlder belts with belt pads
3 b
S lots to adjust shoulder belts
4
S upport pillow
5
C arrying handle
6
P ush button for adjusting carrying handle
7
Belt hook for lap section of safety belt
8
R ear belt hook for shoulder section of safety belt
9
B elt tensioner strap
10
C ontrol button of the quick adjuster
11
C ontrol button for removing car seat from
12
Bébé Confort frame
B elt hooks
13
I nstuctions and airbag warning
14
sticker
Rim (for storing sun canopy)
15
S un canopy (built-in)
16
Instruction manual
17
S torage compartment
18
M ounting bars for FamilyFix and EasyBase 2
19
20
Safety
General CabrioFix instructions
1. Y ou are personally responsible for the safety of
your baby at all times.
2. N ever hold your baby on your lap when driving.
3. D o not use the CabrioFix for more than 5 years.
4. D o not use second-hand products where the
history is unknown.
5. R eplace the CabrioFix after an accident.
6. R ead this instruction manual carefully and keep
it in the storage compartment in the CabrioFix.
Warning: Do not make any changes to the
CabrioFix whatsoever, as this could affect the
performance of the car seat and render
it unsafe.
CabrioFix maintenance instructions
1. T he CabrioFix must undergo regular
maintenance. Do not use lubricants or
aggressive cleaning agents.
2. T he cover, cushions and belt pads of the
CabrioFix can be removed in order
for these to be cleaned (also see washing
instructions). The flexible plastic edge can be
cleaned with water, soap and a soft cloth.
3. I f the cover needs to be replaced at any time,
only use official fabrics.
The CabrioFix and your baby
1. Never leave your baby unattended.
2. A lways secure your baby with the harness belt.
3. B efore every use, make sure the harness is not
damaged or twisted.
4. M ake sure you can fit no more than one finger
between the harness and your baby (1cm).
5. O nly use the support pillow of the CabrioFix
when the shoulder belts are in the lowest
position.
Warning: Never place the CabrioFix on an elevated
surface (such as a table or chair).
CabrioFix car use
1. A lways check to make sure the car seat can be
installed properly in your car before purchasing
it.
2. M ake sure that any fold-down rear seat is locked
into position.
3. P revent the CabrioFix from becoming trapped or
weighed down by luggage, seats and/or
slamming doors.
4. M ake sure that all luggage and other loose
objects are secure.
EN
5. T he safest place for your baby is the rear of your
vehicle, however if you need to install the seat in
the front passenger seat, please ensure that any
airbag is deactivated.
6. O nly use a forward-facing seat that is fitted with
a 3-point safety belt that complies with the ECE
R16 standard (at a minimum).
7. M ake sure the car safety belt buckle runs in a
straight line and stays below the belt hook of the
CabrioFix. See the p.8 example.
8. The car safety belt must be threaded along
all blue markings. For proper installation
instructions, see pages 8-9 and/or the sticker
on the side of the CabrioFix.
9. A lways cover the CabrioFix when exposed to
direct sunlight in the car. Otherwise, the cover,
metal and plastic parts could become too hot for
your child's skin.
Warning: The CabrioFix may only be installed in a
rear-facing position in the car.
21