HP Smart Wi-Fi Display Manuel De L'utilisateur page 48

When I connect my frame to my PC, the PC doesn't show any drive
letters, or the frame appears as a "PTP/MTP Device"
Your frame may be configured for a PictBridge printer connection instead of a PC
connection. To correct this, follow these steps:
Disconnect the frame from your computer,
1.
Go to the Main Menu of the frame, select Setup, then Local Settings. Make
2.
sure that USB Mode is set to PC and not Printer.
Using the Power switch on the back of the frame, switch the frame off and on
3.
again (for the location of the Power switch, see "Back" on page 12)
Re-connect the frame to your computer.
4.
My wireless network doesn't appear on the list of available
networks
The wireless network access point may not be working correctly or may not be
properly configured. Ensure that other devices can connect to the network to rule out
this possibility.
The signal from the wireless network may not be strong enough. Try moving the
location of the access point or the HP Smart Wi-Fi Display for better signal
reception.
Your network's SSID may not be broadcasting. In this case, use the Setup Hidden
Network WEP, Setup Hidden Network WPA or Setup Hidden Network
Open option on the list of available networks.
I can't access my Internet Content
Your wireless network connection may not be working correctly. Ensure that you are
connected to the wireless network and that it has access to the Internet.
I can't remember the settings for my wireless router
Consult your router documentation on how to access your router's configuration
parameters. As a last resort, most routers have a mechanism to reset itself back to
factory defaults.
46