Running The Wireless Network Configuration Wizard On Your Computer (Optional) - HP Smart Wi-Fi Display Manuel De L'utilisateur

Running the Wireless Network Configuration Wizard on
your Computer (optional)
As an alternative to manually entering Wi-Fi details into your HP Smart Wi-Fi
Display, you can use the Wireless Network Configuration Wizard on your computer.
Windows XP (Service Pack 2 or later)
On your computer, click Start > Control Panel
1.
Double-click Wireless Network Setup Wizard.
2.
The Wireless Network Setup Wizard begins. Click Next.
3.
If the wireless network you wish to connect to has not previously been set up on
4.
your computer, check the check box beside Set up a new wireless
network. Click Next.
Alternatively, if the wireless network you wish to connect to has previously been
set up on your computer, check the check box beside Add new computers
or devices to the **** network, where "****" refers to the name of your
wireless network. Click Next.
If you have chosen Set up a new wireless network in the previous step,
5.
you will now be asked to enter the Network name (SSID), choose whether to
have Windows assign a network key automatically (check the box beside
"Automatically assign a network key"), or enter one manually (check the box
beside "Manually assign a network key"), and finally choose whether to check
the box beside "Use WPA encryption instead of WEP" depending on which type
of security your network uses. Click Next.
If you have chosen to enter the network key manually in the previous step, you
6.
will be asked to do so now (then click Next). If you have chosen to have
Windows assign a network key automatically, then this step is skipped.
Check the check box beside Use a USB flash drive (recommended). Click
7.
Next.
Plug your USB flash drive into any USB port on your computer and then wait for
8.
the drive letter to appear in the "Flash drive" field. Click Next.
When advised to do so, remove the USB flash drive and plug it into your HP
9.
Smart Wi-Fi Display to finish the set up of the Wi-Fi connection.
Once the Smart Wi-Fi Display Wi-Fi connection is set up, unplug the USB flash
10.
drive and plug it back into your computer. Click Next.
Click Finish.
1 1.
15