Maintenance - Haussmann DP1000 Manuel De L'utilisateur

ADJUST DEPTH STOP
Refer to Figure 16
The depth stop is attached to the quill with hex hut that
can be lowered or raised on the stud. To set the depth
stop:
• Lower the drill bit to the desired height by using the
handles.
• Hold the feed handle at the desired position.
• Use wrench to spin the lower lock nut down to contact
the depth stop and lock the nut.
• Spin the upper nut against the lower stop nut and
tighten.
• The drill bit will stop after traveling the distance on the
depth scale.
Figure 16
Depth Gauge
WARNING
Turn the switch to "OFF" position and disconnect the
machine from power source before servicing or disassem-
bling any components.
CLEANING
• Keep machine and workplace clean. Avoid
accumulation of sawdust on the tool.
• Be certain motor is kept clean and free of dust.
• Use soap and water to clean painted parts, rubber parts
and plastic guards.
ADJUST BELT TENSION
Refer to Figure 17
The drill spindle speed is determined by the position of the
belts on the pulleys inside the head assembly.
• To unlock the belt tension, turn the belt tension lock
knob on the right side of the drill press head
counterclockwise.
• Pull the motor toward the front of the drill press to
loosen the belt tension.
• Position the belt on the correct pulley steps for the
desired speed.
• Push the motor away from the drill press head until the
belt is properly tensioned.
• Belt tension is correct if the belt deflects approximately
1/2 inch when pressed at its center.
• Tighten the belt tension lock knob to secure the motor in
position.
Figure 17
Lock Knob

MAINTENANCE

LUBRICATION
• Internal bearings have been permanently lubricated at
the factory and do not require any additional lubrication.
• A light coat of paste wax on the work table will facilitate
piece movement and prevent rust.
TOOL REPAIRS
• If power cord is worn, cut or damaged in any way, do
not operate the machine.
• Replace any worn, damaged, or missing parts. Use the
parts list on page 26 to order parts.
• Any attempt to repair motor may create a hazard unless
repair is done by a qualified service technician.
• Call the customer line at 1-866-206-0888.
23
Belt Tension
Lock Knob