Haussmann DP1000 Manuel De L'utilisateur page 20

INSTALL THE DRILL PRESS HEAD
Refer to Figure 4.
• Position and slide the head over the column.
• Carefully rotate the head on the column so it is aligned
with the base.
• Secure the drill press head with two lock set screws,
using the hex wrench.
Figure 4
INSTALL HANDLES
Refer to Figure 5.
• Locate the three thread holes on the hub of the head.
• Thread the handles into the holes of hub until tight.
Figure 5
HUB
INSTALL THE CHUCK
Refer to Figure 6.
Clean the spindle taper and the tapered hole in the chuck
before assembly. Remove factory protective coating with
alcohol or household oven cleaner.
• Rotate the chuck sleeve counterclockwise and open the
jaws as wide as possible.
HEAD
• Place chuck on the taper of spindle and gently tape the
ASSEMBLY
chuck into position with a rubber hammer or a hammer
with wood block. Never use metal hammer directly.
Figure 6
SET SCREW
MOUNT DRILL PRESS
Refer to Figure 7
• The machine must be installed in a well-lighted area
with correct power supply.
• The machine can be installed on either a workbench or
a tool stand by using bolts, lock washers, and hex nuts.
• The machine must be bolted to a firm and level surface.
• There must be proper clearance to adjust the workpiece
FEED
HANDLE
Figure 7
19
WARNING
HEAD
ASSEMBLY
ARBOR
CHUCK
SCRAP
WOOD
MALLET
before and after the operation is complete. There must
be sufficient room to safely operate the machine.
Mounting Holes