Motor - Haussmann DP1000 Manuel De L'utilisateur

ADJUST SPEEDS
Refer to Figure 13
WARNING
Turn the switch to "OFF" position and disconnect the
machine from power source.
This drill press has 5 speeds: 620 RPM, 1100 RPM,
1720 RPM, 2340 RPM and 3100 RPM. The speed is
determined by the location of the belt on the
pulleys. The speed chart shows the pulley configuration
for each speed.
Figure 13
Spindle
5
4
3
2
1
Belt
Belt Location Speed (RPM)
Location RPM
5-5 3100
5-5 3100
4-4 2340
4-4 2340
3-3 1720
3-3 1720
2-2 1100
2-2 1100
1-1 620
1-1 620
INSTALL DRILL BIT
Refer to Figure 14
• Insert the chuck key. Rotate counterclockwise to loosen
the chuck jaws so that the opening is slightly larger than
the bit size you intend to use.
• Insert the smooth end of drill bit all the way into the
chuck. Slightly pull back the drill bit by 1/16". If the spiral
groove (flute) of drill bit is still inside the chuck, pull
further until the spiral groove is free from chuck
jaws' grip when tighten.
• Turn chuck key clockwise to tighten the chuck jaws.
Check to see the drill bit is centered and secure in the
chuck.
• Remember to remove chuck key before operating the
machine.
Figure 14
Chuck Jaws
Drill Bit 3
ADJUST LASER ALIGNMENT
Refer to Figure 15
• Check the laser alignment to ensure the intersection of
laser lines is precisely at the spot where the drill bit
meets the workpiece. If it is not, loosen the Laser
Adjustment screws which allow for the adjustment of the
Laser lens by rotating to the intersection point.
• Mark an "X" on the workpiece to mark the drilling point.
• Align the drill bit tip to the intersection of the lines of the
"X".
• Secure the workpiece on the table.
• Turn on laser and verify if the laser lines align with the
"X".

Motor

• If it is not, loosen the laser alignment screws with a
5 Phillips head screwdriver.
• Adjust the lasers by turning the red laser lens caps to
4
align the beams to the intersection of the "X".
3
• Retighten the screws to secure laser position.
2
1
Figure 15
• Remember to remove chuck key before operating the
machine.
A laser light is radiated. Avoid direct eye contact. Always
turn off the laser when the laser is not in use.
• Keep children away from laser device. Misuse of laser
can result in irrepairable eye injuries.
• Do not do any adjustment to increase the laser power.
• Do not point the laser beam towards people and /or
reflecting surfaces.
• Do not look directly into the laser beam.
• Never open the laser housing for repair or adjustment.
• Laser warning label: Max output <5mW DIODE
LASER: 630-660nm, Complies with 21CFR 1040.10 and
1040.11.
Chuck Key
22
Laser Adjustment
Screw
WARNING
Laser Switch