Operation, Hints And Tips - Ferm TDM1025 Traduction De La Notice Originale

• Since the drill spindle is greased in the factory,
it is advisable to run in the machine for
approximately 15 minutes at the lowest speed.
Before you push the chuck with pin (9)
into the drill spindle, the inside of the
chuck must be completely grease-free!
Setting up the bench drill
Before use the drill must be mounted on a fixed
base. The footplate (13) has therefore been
provided with drilling holes. By means of screws
the footplate can be fixed to the base in this place.
If it is mounted on a wooden board, sufficiently
large washers must be used on the opposite side,
so that the bolts are not pushed into the wood and
the machine cannot become loose.
The fastening screws may be fastened so
far that the footplate is not under tension
or deformed. When the tension is too high
there is a risk of breakage.
Adjusting the number of revolutions of the
drill spindle
Fig. C
The different revolutions of the drill spindle can be
adjusted by shifting the V-belt into the belt drive.
The machine is protected by a safety switch so
that the machine is automaticly switched off when
opening the casing. The V-belt is shifted as
follows:
• Open the V-belt cover (14) by loosen the
screw on the right side of the cover.
• Loosen the fastening button (18) and slide the
engine in the direction of the machine head,
upon which the V-belt is released.
• Shift the V-belt according to the table on the
inside of the V-belt cover.
• Tension the V-belt again by pushing the
engine plate (17) to the back. Then the
tensioning device is fastened with the
fastening button (18).
• Close the V-belt cover and the machine is
ready again for use.
Keep the V-belt cover closed during use.
Fig. C & D
If you have shifted the V-belt, you must tighten it
again by means of the engine plate (17) with the
fastening button (18). The tension is correct when
Ferm
the V-belt can be pressed in by approximately 1
cm. The engine pulley must be aligned
horizontally, so that early wear and loosening of
the V-belt can be prevented. For this purpose the
engine pulley (15) on the engine can be slid along
the engine axle, after loosening the socket head
screw.
Spindle speeds
Fig. E
Position V-belt
1
2
3
4
5
The number of revolutions of the drill spindle of the
V-belt combinations can be read from the
illustration and the table.
Drill spindle and drill head pin
All the blank parts of the machine are provided
with a protective lacquer layer, which prevents rust
formation. This protective lacquer layer is easy to
remove by means of environmentally friendly
solvents. Test the V-belt tension before you
connect the machine to the electricity mains. The
inside of the drill spindle must be degreased
completely. For this purpose use environmentally
friendly solvents. Proceed in the same way with
the drill head pin. A correct transmission can only
be achieved in this way.

4. Operation, hints and tips

Depth stop
The drill spindle is provided with a depth stop. It
can be adjusted using the nut. The drill depth can
be read on the scale division.
Clamping the drill
Fig. F
In the drill head of the bench drill, drills and other
tools with a cylindrical shank can be clamped. The
moment of rotation is transferred to the drill by
means of the tension of the three clamping jaws.
To prevent the drill from sliding away, it must be
clamped using the toothed ring wrench. If the drill
slides away in the drill holder, a slight burr occurs
on the drill shank, which makes centric clamping
impossible. A burr which occurs in this way must in
any case be removed by grinding.
EN
Revolutions/min
2650
1650
1220
850
580
7