Operating Instructions; Attach The Hose Tip; Maintain Water Level - Interacoustics Aqua Stim Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 103
Aqua Stim Water Irrigator Instructions for Use - EN

3 Operating instructions

3.1 Attach the Hose Tip

Use Interacoustics provided soft silicone hose tips placed on the end of the delivery handle. The silicone
Tips are single-use-only to prevent transmission of disease between patients. Only use silicone tips from
Interacoustics.
To assemble the silicone tip on the delivery handle, slide the tube over the short stainless steel nipple as
shown in Figures 4 and 5. Confirm the silicone tube is on straight and that it tightly grips the nipple.
Figure 5 Place silicone tip on irrigation handle
nipple. Use silicone Tips provided by
Interacoustics that are calibrated for flow rate
and heat transfer.

3.2 Maintain Water Level

As a good practice, verify the external water tank is filled completely with water at the start of the day. A full
water tank holds enough water for approximately 14 irrigations. The irrigator will alert you if there is not
enough water in the tank to perform the next irrigation by displaying "No water in tank".
For optimal operation, the water in the external tank should be kept between 68°F (20°C) and 75°F (24°C).
Warm water in the tank above 27°C will prevent 30°C irrigations. If the tank water is too warm for the 30°C
irrigation, you may add cool water or a few ice cubes to the external tank. Power down, power up and press
the "Cool" button to flush the internal tank with cooled water.
If you have not used or do not plan to use the irrigator for a couple of weeks, drain the irrigator using the
drain procedure in the Error! Reference source not found. to remove any water. Then empty the external
tank.
You should always use fresh water in the external tank.
the Aqua Stim provided that the water is not "hard water" due to excess mineral
content. Build up and / or damage from mineral deposits is not covered under
warranty.
be used if the tap water is "hard" due to mineral content or if there is any question in
your mind about water purity. Unclip and remove the top from the external water
tank. Wash the container weekly using mild dish soap. Rinse the tank after
washing to remove soap residue. Replace cover and check tube connections. Fill
with fresh, clean water.
Figure 6 Pull lightly on silicone tip to verify it is secure.
Demineralized or distilled water
Tap water
may be used in
is always recommended and should
Page
11

Publicité

Table des Matières
loading

Table des Matières