Watts BT-CT02 Mode D'emploi page 12

You can now select the
hydraulic circuit linked to this receiver (e.g.
circuit 1).
Repeat the procedure for each device of
the room (zone) you want to link to the
hydraulic circuit. Further devices can be
selected using the buttons [<<<] or [>>>] at
the top of the device name.
Repeat the procedure for each room (zone)
that you want to link to hydraulic circuit
1. If you have assigned all rooms / devic-
es, repeat the procedure for any further
hydraulic circuits.
STEP 2: pairing radio receiver hydraulic
circuit with the central unit
For each circuit, you can link a circuit receiver
to drive the pump devices, valve drive or
heat / cool generator of the circuit. This can
be done for example by BT-WR02 RF.
Select "Circuit", then select the number
of the circuit, e.g. circuit 1. Put the radio
receiver in pairing mode (BT WR02 RF).
Repeat the procedure for additional
hydraulic circuits.
12
Heat and Cool installations
If your installation includes both heating and
cooling functions, you can switch either
from Heat to Cool manually or automati-
cally:
• If you have a BT HCM02 RF in your
installation set as "Master" (refer to
Manual instruction of the device) then
all is automatic you don't have to do
anything
• For all other cases, you have to do the
switch manually:
There you will have the choice netween
"Heating Only" "Cooling Only" or "Manual
Reversible". With this last option, you cre-
ate a shortcut in the main menu where you
can easily change Heat/Cool mode.
Notes:
• In Cooling Mode, Reduced mode and
Antifreeze mode are inactive:
icon is displayed
instead of
• In the thermostat, user can configure
the parameter "Cold" that allows the
zone to do Cooling or not. If it is set
to "No", then if the mode of the zone
is Cooling then the zone won't make
Cooling.
2019 / 06 Watts | PPLIMW15428C
ENGLISH
EN
and go in "H&C".
or .