Miele GDU 45/60-1 Notice D'installation page 23

^ Remove the decor strips, decor
panel, filler card and polystyrene
spacers.
,
Use masking tape along the
cutting line to protect the panel and
strips from damage during cutting.
Use a cutting tool suitable for the
material. If in doubt contact a
qualified fitter.
When using the decor panel
supplied:
^ Shorten the decor strips, decor
panel, filler card and polystyrene
spacers from the top by dimension X
(as previously calculated).
When using a new decor panel:
If you are using a decor panel which
matches your kitchen units, cut it to the
following size:
60 cm wide dishwashers:
Height = 605 mm minus
Dimension X (as previously calculated)
Width = 585 mm
45 cm wide dishwashers:
Height = 605 mm minus
Dimension X (as previously calculated)
Width = 435 mm
XXL dishwashers:
60 cm wide XXL models:
Height = 655 mm minus
Dimension X (as previously calculated)
Width = 585 mm
If the new decor panel is thicker than 2
mm (max. 4 mm), remove the filler card
from the front panel.
^ Shorten the decor strips, polystyrene
spacers and if necessary, the filler
card from the top by dimension X (as
previously calculated).
For all the above cases:
^ Reassemble the front panel and fit to
the dishwasher as described in step
2.
^ Push the dishwasher right back into
its recess and make sure it is aligned
correctly. Proceed to step 6.
G
23