Miele GDU 45/60-1 Notice D'installation page 21

2. Fitting the front panel
^ Push the front panel up at an angle
under the fascia panel a and then
into the slots on the door front outer
panel b.
Make sure that the top edge of the
front panel slides up and fits neatly in
place under the fascia panel.
^ Tighten the TORX T20 screws c
located on either side of the door
front outer panel.
^ Use the plastic stoppers supplied to
blank off the openings in the fixing
mechanism.
3. Aligning the dishwasher
Push the dishwasher into the recess
and align it as described on the
"Installation diagram for built-in
dishwashers".
If you want to build the dishwasher
into a corner you must first attach
the fixing plate to the approriate side
of the dishwasher (see "Installation
diagram for built-in dishwashers").
If you are using the decor panel
supplied and the lower edge aligns
with the lower edge of the
neighbouring kitchen cabinets you
can miss out steps 4 and 5 and
continue from step 6.
G
21