Program Dry Operation; Adjusting The Air Flow Direction - Daikin LRYEQ16AY1 Manuel D'utilisation

Defrost operation
• In heating operation, freezing of the outdoor
unit heat exchanger increases. Heating
capability decreases and the system goes
into defrost operation.
• The indoor unit fan stops and the remote
controller displays "
• After maximum 10 minutes of defrost opera-
tion, the system returns to heating operation
again.
Hot start
• In order to prevent cold air from blowing out
of an indoor unit at the start of heating oper-
ation, the indoor fan is automatically
stopped. The display of the remote controller
shows " ".
NOTE
• The heating capacity drops as the outside tem-
perature falls. If this happens, use another heat-
ing device together with the unit. (When using the
appliances which produce open fire together, ven-
tilate a room constantly.)
Do not place appliances which produce open fire
in places exposed to the air flow from the unit or
under the unit.
• It takes some time for the room to warm up from
the time the unit is started since the unit uses a
hot-air circulatory system to warm the entire
room.
• If the hot air rises to the ceiling, leaving the area
above the floor cold, we recommend using the cir-
culator (the indoor fan for circulating air). Contact
your dealer for details.

5-2 PROGRAM DRY OPERATION

• The function of this operation is to decrease the
humidity in your room with a minimum tempera-
ture decrease.
• The micro computer automatically determines
temperature and fan speed.
• The system does not go into operation if the room
temperature is low.
• The microcomputer automatically controls the
temperature and fan speed, so these cannot be
set using the remote controller.
• This function is not available if the room tempera-
ture is 20°C or lower.
English
".
1
2
3
4

5-3 ADJUSTING THE AIR FLOW DIRECTION

1
Fig.3
Press the operation mode selector button sev-
eral times and select "
ation).
Press the on/off button.
The operation lamp lights up and the system
starts operation.
Press the air flow direction adjust button (only
for FXC, FXF, FXH). Refer to the chapter
"Adjusting the air flow direction" for details.
Press the on/off button once again.
The operation lamp goes off and the system
stops operation.
NOTE
• Do not turn off the power immediately after
the unit stops.
• The system need at least 5 minutes for
residual operation of drain pump device.
Turning off the power immediately will cause
water leak or trouble.
(only for Double-flow, Multi-flow, Ceiling-
suspended)
Fig.4
Press the air flow direction button to
select the air direction.
The air flow flap display swings as
shown right and the air flow direction
continuously varies. (Automatic swing
setting)
" (program dry oper-
7