Maintenance; Service; Troubleshooting - Bosch NET8654UC Notice D'utilisation

Maintenance

This appliance requires no maintenance other than daily
cleaning. For best results, apply cooktop cleaning cream
daily.

Service

Troubleshooting

If you encounter a problem, it often will merely be
something minor. Before you call customer service,
consider the suggestions and instructions below:
Fault
Cooktop is not working The electric power supply has been
is flashing on the ele-
"
ment display
" flashes on all ele-
ment displays. An
accoustic signal
sounds
The cooktop turns off
by itself
and numbers A fault in the electronic system has
Display
"
and numbers A fault has been detected.
Display
"
Error messages
Display
"ƒ
"...
Possible cause
interrupted.
The appliance has not been cor-
rectly connected following the con-
nection diagram.
Electronic system malfunction.
The touch control zone is wet, very
dirty, food has boiled over, or an
object is lying on top of the touch
control zone.
The main switch has been activated
continuously for more than 5 sec-
onds.
The main switch has been touched
unintentionally.
occurred.
Fault
The element is too hot and has
turned off.
The touch control zone is too hot.
CAUTION
9
Repairs should only be done by a trained servicer.
Improper repair of your appliance may result in risk
of severe physical injury or death.
Measure
Use other electrical appliances to check if there has
been a power outage. Check to see if there is a prob-
lem with the circuit breaker for the electrical installa-
tion.
Make sure that the appliance has been connected cor-
rectly.
Contact the Technical Assistance Service.
Clean the touch control zone, or remove the object.
Lightly touch the corresponding touch key. The flash-
ing should stop.
Press the power key again. Reset the cooktop.
Press the main switch again. Reset the cooktop.
Turn the appliance off and back on at the fuse or cir-
cuit breaker. If the same fault occurs again, discon-
nect the appliance and call Technical Assistance
Service.
The following table of error messages lists actions you
can take to correct the problem
Measure
Remove the pans from the elements.
when you press the display, if the element has cooled
down sufficiently. Wait a few minutes until the element
has cooled down a bit. If
element is turned back on, the cooktop is still too hot.
Turn off the elements and allow them to cool further.
Make sure that cookware is properly positioned on the
element, and no hot objects are in contact with the
touch control zone. Wait a few minutes until the touch
control zone has cooled down. If
turn on the appliance, call Technical Assistance Ser-
vice.
disappears
"ƒ
appears again after the
"ƒ
appears after you
"...
19