Changing The Battery; Maintenance; Technical Data; General Conformity Declaration - Selve i-Marki Control W Notice D'utilisation

GB
Changing the battery/Technical Data

Changing the battery

Maintenance

Clean the device with a damp cloth only. Do not use a cleansing agent
since this could damage the plastic.

Technical data

Nominal voltage:
Switched current:
Battery type:
System of protection:
Protection class:
Permissible
ambient temperature:
Type of installation:
Subject to technical modifications.

General conformity declaration

The company SELVE GmbH & CO. KG, hereby declares that the
i-Marki Control W/WS is in conformity with the basic requirements
and other relevant provisions of the Directive 73/23/EWG and
89/336/EWG. The declaration of conformity can be seen at
www.selve.de.
1. Disconnect the operating device.
2. Remove the battery.
3. Insert the new battery properly
(CR 2032).
4. Reset the time.
Note: The values set are still saved.
230–240 V AC/50–60 Hz
5 A/250 V AC for cos φ = 1
CR 2032
IP 20 for i-Marki Control
IP 33 for i-Marki Sensor W/WS
II provided the device has been properly
installed in accordance with the specifi-
cations
0 to +55 °C
Concealed Ø 58 mm wall-mounted,
exposed in appropriate exposed casing
62