Selve i-Marki Control W Notice D'utilisation page 48

GB
Explanation of functions/terms used
DELAY (only when EXPERT MODE is ON)
The delay time
set to 15 min.
The delay time
threshold setting SUN
is executed. This setting can be made manually
The delay time
sunlight reading falls below the pre-set threshold value SUN
and the 'retract' control command is executed. This setting can
be made manually.
END LIMIT
The end limit is the point where the sun protection system has
reached the upper or lower end position.
INTERMEDIATE POSITION
The intermediate position is a position of the sun protection
system between the upper and lower end limits that can be free-
ly selected. This position can be reached from the upper position
after programming.
Press the DOWN button twice in rapid succession to move to the
intermediate position.
When the system is in venetian blind mode, it is also possible to
programme a reversing position. In this case, this command will
be automatically executed following the intermediate position
command.
CANOPY TENSION/TILT
The canopy tension/tilt position is a position of the sun protection
system/venetian blind between the upper and lower end limits that
can be freely selected. This function can be used to make the
canopy of your sun protection system taut.
In the case of venetian blinds, the blind slats are turned.
Press the UP button twice in rapid succession to move to the
canopy tension/tilt position.
WINTER ON/OFF
If the WINTER ON function has been activated, no automatic and
manual control commands are executed.
is pre-set to 3 min. and the delay time
indicates the period between the moment the
is exceeded and the control command
indicates the period between the moment the
48
is pre-