Selve i-Marki Control W Notice D'utilisation page 59

Programming
FUNCTION
(only when the operating device is disconnected, only for
qualified electricians)
AWNING/VENETIAN BLIND, DRIVE CONTROLLER/GROUP
CONTROLLER, RUNNING TIME
(Curtain/canopy selection, selection of the drive controller/group
controller, running time of the awning/venetian blind)
1. Press the MENU button.
2. To select the FUNCTION menu, press the + button until
FUNCTION appears.
3. Confirm by pressing OK. AWNING/VENETIAN BLIND will
appear.
4. You can select either awning or venetian blind using the
+/- button.
5. Confirm by pressing OK.
DRIVE CONROL DEVICE/GROUP CONTROLLER will appear.
6. You can select the control device required using the +/- button
(DRIVE CONROL DEVICE/GROUP CONTROLLER).
7. Confirm by pressing OK. RUNNING TIME will appear.
8. You can set the required running time using the +/- button
(default setting: 120 seconds).
9. Confirm by pressing OK.
10. The RUNNING TIME function has now been set.
Please read on for further programming options using the
FUNCTION menu.
59
GB