Turn The Loophear Tm On; Installation And Operation - Geemarc LoopHEAR 102 V2 Mode D'emploi

USING THE LoopHEAR
Turn the LoopHEAR
Turn the power switch found at the rear of the
1
unit to the position. The power indicator
RED LED next to the switch lights up.
Turn the LoopHEAR
After use, turn off by setting the power switch at the back of the
unit to the 0 position.
INSTALLATION & OPERATION
1. Choose a suitable location, free from
magnetic or electrical interference for
installation and use of LH102. Install
the LH102 ensuring that the cables are
securely anchored.
2. Connect the desktop Microphone to
the Mic jack. (or If needed connect an
Aux device to the Aux input jack).
Please note that if an Aux device is
connected, the MIC will be switched off.
3. Switch on the external power and
check that the Power ON LED
illuminates.
4. Apply the input signal (for example
speaking into the Mic) to Mic or
playing some music on the Aux device.
(For the Aux input the sensitivity can
be adjusted with a small flat blade
screwdriver via the control which need
to be turned until the green LED start
to light).
TM
On
TM
Off
11
TM