Using The Device - Atlantic NEFERTITI Notice D'utilisation Et D'installation

Description of the control panel
D
C
B
A
Use of Comfort mode
It is the temperature desired when the room is occupied.
- Switch on the heating by pressing switch C.
- Turn the temperature wheel A to
perature is less than the desired temperature.
Wait a few hours for the temperature to stabilise.
If the temperature setting does not suit you, adjust it using the adjusting screw A.
Use of Turbo mode
It is the mode enabling to set the device into Forced Operation, ensuring prompt temperature in-
crease in the room over the time defined (fan activation).
- Set Turbo mode's duration by turning wheel D.
For a traditional model, select a duration of 60 to 120 minutes.
For a fan-assisted model, select a duration of 15 to 30 minutes.
- Press the same wheel D to start the Turbo. The "Turbo ON" indicator light illuminates.
The device operates at maximum output for the desired duration.
After the selected period, the Turbo switches off and the device continues heating in Comfort mode.
Use of Frost Protection mode
It is the mode enabling to maintain a temperature of approximately 7°C in the room in case of pro-
longed absence from the house.
- Turn the wheel A to
Locking the device's settings.
It is possible to lock the wheel A or restrict its use, preventing untimely handling of the device (chil-
dren...).
- Set the temperature wheel A to the desired position.
- Hold down switch C for approximately 5 seconds.
Switch C flashes for 2 seconds: the wheel's position is recorded.
The "Heating OFF (switch C) and TURBO modes (wheel D) remain active.
The controls are no longer accessible. The setting is locked.
Hold down switch C again for 5 seconds to unlock the device's settings.
U
SING THE DEVICE
A
B
C
D
, the heating indicator light B illuminates if the ambient tem-
.
Bathroom comfort temperature control wheel
Heating indicator light
Heating ON/OFF switch and indicator light
Turbo mode ON / OFF and duration control
wheel
17
GB