Publicité
Les langues disponibles
Les langues disponibles
PARTS
1.
On-off button
2.
Speed control
3.
Handle
4.
Button for removing handle
5.
On-off button hand-held
6.
Unlock button for dust reservoir
7.
Release button floor nozzle
8.
Floor nozzle with rotating floor brush
9.
Charging station cord
10. Charging station
11.
Crevice vacuum cleaner
10
BEFORE THE FIRST USE
To set up the machine properly, please follow the steps below:
1.
Slide the handle in to the upright vacuum cleaner until you hear a click.
2.
Make sure that the floor nozzle is clicked on tightly to the stick vacuum cleaner.
CHARGING
1.
Click the two parts of the charging station together before use.
2.
Attach the charger to the charging station via the in-built
connector on the back.
3.
Put the stick vacuum cleaner into the charging station, so that
the contact points on the vacuum cleaner are aligned with the
contact points on the charging station. Push the vacuum cleaner
and the charging station together so that the stick vacuum cleaner remains standing vertically on
the station. Make sure it all is stable.
4.
The on/off button of the hand-held vacuum cleaner will light up red and will become green once the
appliance has been fully charged. This light will turn off after a while.
5.
The machine cannot be started during charging.
USE
·
Press the on-off button on the handle to turn the machine on. The on/off button of the hand-held
vacuum cleaner is green. If the battery is almost empty, the light will flash on and off.
·
When you switch on the machine, the rotating floor brush at the bottom of the floor nozzle will begin
to turn. This will cause the dirt in the opening to be shifted and thereby vacuumed up.
·
Press the speed control to increase or lower the suction power.
20
DO1013SV
11
9
1
2
3
4
5
6
7
8
MAX FILL
Publicité
