Lenze L-force 9400 Instructions De Montage page 40

1 Safety instructions
General safety and application notes for Lenze controllers
Operation
If necessary, system including controllers must be equipped with additional monitoring
and protection devices according to the valid safety regulations (e.g. law on technical
equipment, regulations for the prevention of accidents). The controller can be adapted to
your application. Please observe the corresponding information given in the
documentation.
After a controller has been disconnected from the voltage supply, all live components and
power connections must not be touched immediately because capacitors can still be
charged. Please observe the corresponding stickers on the controller.
All protection covers and doors must be shut during operation.
Note for UL approved systems with integrated controllers: UL warnings are notes that only
apply to UL systems. The documentation contains special information about UL.
Safety functions
Certain variants of the drive controllers support safety functions (e.g. "safe standstill")
according to the requirements of Appendix I No. 1.2.7 of the EC Machinery Directive
98/37/EG, EN 954-1 Category 3 and EN 1037. It is absolutely necessary to observe the
notes to these safety functions in the documentation to the variants.
Maintenance and servicing
The controllers do not require any maintenance, if the prescribed conditions of operation
are observed.
If the ambient air is polluted, the cooling surfaces of the controller may become dirty or the
air vents of the controller may be obstructed. Therefore, clean the cooling surfaces and air
vents periodically under these operating conditions. Do not use sharp or pointed tools for
this purpose!
Disposal
Recycle metal and plastic materials. Ensure professional disposal of assembled PCBs.
The product-specific safety and application notes given in these Operating Instructions
must be observed!
40
EDK94ASH24 DE/EN/FR/ES/IT 3.0