Lenze L-force 9400 Instructions De Montage page 35

Quick start guide
How to proceed for the installation:
1. Read the safety instructions
2. Install the mounting base in the control cabinet
3. Wire the mounting base
4. Insert the basic device into the mounting base
5. Wire the basic device
6. Adjust and wire the device modules
– Wire the communication modules.
– Adjust the memory modules.
– Wire the safety modules.
7. Final works
Tip!
Current documentation and software updates for Lenze products can be found on the
Internet in the "Downloads" area under
http://www.Lenze.com
© 2005 Lenze Drive Systems GmbH, Hans-Lenze-Straße 1, D-31855 Aerzen
No part of this documentation may be reproduced or made accessible to third parties without written consent by Lenze Drive
Systems GmbH.
All information given in this documentation has been selected carefully and complies with the hardware and software described.
Nevertheless, deviations cannot be ruled out. We do not take any responsibility or liability for damages which might possibly occur.
Necessary corrections will be included in subsequent editions.
EDK94ASH24 DE/EN/FR/ES/IT 3.0
The safety instructions
page 38.
The listing of the mounting dimensions
starts on page 43.
The description of the connections
starts on page 46.
The installation description starts on
page 50.
The listing of the terminal assignment
starts on page 51.
Information on the device modules
starts on page 55.
The description of the final steps starts
on page 63.
start on
35